F1

Fine Filter

The fine filter F1 is a stainless steel 1.4404 or brass manufactured filter with a replaceable filter element made of sintered bronze or stainless steel.

The built-in filter element holds back solid particles to 20 or 40 micron and permits only cleansed gases or liquids to flow to the following equipment.

This fine filter is equipped with a standard internal thread G1” at the in- and outlet.

In order to constantly have the maximum flow capacity available, it is advisable to periodically examine the filter element and replace when necessary.

Make an Enquiry

Technical Details
Application Area
Order Details

Body:	brass / stainless steel
Max. inlet pressure:	420 bar
Operating temp.:	-20°C to +70°C
Connections:	in-/outlet: G 1" f

Urgently recommend the use of this filter element in connection with the pressure regulators D1, DH1 and L1, where the accuracy and life span of pressure regulators can be substantially increased with a clean medium.

Further application areas exist in high pressure pneumatics for the protection of sensitive measuring equipment and controllers.

To identify the correct order code for your FH1

Start with the model number, then add the appropriate number options from columns A & B in the table below followed by the gas to be used.

FH1-1-1-Argon specifies a FH1 model in brass with bronze 20 μ filter element, for use with Argon gas.

A	B
Material	Filter Element
1 = brass	1= bronze 20 μ
2 = stainless steel	2 = bronze 40 μ
	3 = stainless steel 20 μ
	4 = stainless steel 35 μ